EKTS is a simulator for designing electromechanical systems. It allows you to design variety of electromechanical systems using relays, time relays, buttons.
![]() ![]()
Motor Controller Software Installation and Programming 1. Software Use and Calibration The interface, “WEBControllerPRO”, is a utility program which operates on Windows NT/XP operating systems. The program provides a fairly intuitive away to tune and calibrate the motor controllers operating parameters. https://honame.weebly.com/blog/teamviewer-5-free-download-for-mac. The controller uses either COM1. Mac Motor Hub Motor; Note: This is not a typical controller where amperage controls it, it's based on wattage. So if you have a lower voltage, it's going to pull more amperage. Wattage is peak rating on these option descriptions, not continuous. Mac excel 2011 postgresql driver download. So a 4000W is programmed to run for up to 4000W, 2000W is programmed to run for up to 2000W.
Mac Talk Motor Controller Programmer Download Software
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |